21A3094
FIRST
CLASS
STAMP
HERE
MODEL 525W
IN-WALL HOME THEATER SPEAKER
OWNERS MANUAL
4545 E BASELINE RD
PHOENIX AZ 85040-6400
STEP 4
LOUDSPEAKER PLACEMENT
Attach loudspeakers wires to speaker terminals, observing correct
polarity (positive to positive and negative to negative), and
position panel and frame assembly to hole as shown. Insert top of
mounting frame into hole at top. By moving bottom of frame
upwards, you should now be able to insert bottom of frame into
hole at bottom. Be careful not to pinch loudspeaker wires in the
process. Tighten long screws. Use the integral bubble levels during
tightening to insure straightness of final position.
The Model 525W was designed to work within almost any interior
decorating scheme. It can be installed in virtually any location where flush
mounting is possible. For a quick, easy installation there are integral bubble
levels located on the baffle to insure perfect horizontal or vertical
alignment. Additionally, the Model 525W is magnetically shielded and
can be safely mounted near TV’s for use in Home Theaters.
LEFT/RIGHT FRONT SPEAKERS
For best stereo reproduction, the two loudspeakers should be placed an
equal distance from your listening position and separated so that the
angle between them at the listening position is between 40 and 60
degrees. Note: Although the speaker can be mounted either horizontally
or vertically, the MTM design used in the Model 525W will produce a more
evenly distributed sound throughout the listening area if mounted
vertically.
STEP 5
After speaker panel is secured tightly, test for sound.
For best stereo imaging, we recommend that the units be placed so that
the tweeters are as close as possible to the ear level of a seated listener.
As this is not always possible in keeping with aesthetic design of a
particular room, the Model 525W loudspeaker is designed with a pivoting
tweeter which rotates to allow you to “aim” the high frequencies toward
the listening position.
STEP 6
When you are satisfied the speaker is operational, “aim” the
tweeter, and affix grill. As grill is designed for a snug fit, you’ll need
to position one edge into the slot first, and press or squeeze
around perimeter of the grill, while pushing the leading edge into
the grill slot.
Normal Dispersion
Dispersion After Tweeter Adjustment
CENTER CHANNEL
STEP 1
One of the most important parameters for the center channel
placement is height. Ideally, the center channel is positioned so
that its tweeter is on the same horizontal plane as the left/right
speakers. This establishes a firm image height when special audio
effects are panned from one side to the other, such as a
speeding car moving across the screen. When a large
discontinuity occurs between the heights of the center and
left/right front speakers, the image of the moving object
becomes confused and somewhat unnatural due to shifts in
image height. Note: Although the speaker can be mounted
either horizontally or vertically, the MTM design used in the Model
525W will produce a more evenly distributed sound throughout
the listening area if mounted vertically.
Using a stud finder (available at low cost at most hardware stores)
or other accurate method, locate center point between two
studs and mark. Using template provided, trace hole pattern on
surface of wall.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole
in wall, following traced pattern.
STEP 3
Run loudspeaker wires to sound source location. There are several
methods you can use to accomplish wiring, depending on the
construction characteristics of the room or house. You can add a
professional touch to your installation by using a speaker terminal
plate at the source location. Leave sufficient amount of wire at
speaker location (8 to 10 inches) to complete connection.
|