NuTone Outdoor Ceiling Fan PFC 48 User Manual

INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
Industrial Ceiling Fan  
MODELS: PFC-48 & PFC-56 Series  
CAUTIONS  
MOUNTING  
BRACKET  
WARNING: To reduce the risk of personal injury, do not bend  
the blade brackets when installing the brackets, balancing the  
blades, or cleaning the fan. Do not insert foreign objects in  
between rotating fan blades.  
OUTLET BOX  
WARNING: To reduce the risk of fire, electric shock, or  
personal injury, mount to outlet box marked “Acceptable for Fan  
Support” and use mounting hardware provided with the box.  
UPPER CANOPY  
SPRING WASHER  
WARNING: To reduce the risk of fire or electrical shock, do not  
use this fan with any solid-state speed control device.  
This product must be mounted and wired in compliance with all  
local and national electrical codes.  
NUT  
DOWN ROD  
COTTER PIN  
Before wiring the ceiling fan, turn off electric power at the circuit  
breaker or fuse box and leave off until installation is complete.  
SPRING  
WASHER  
Mount outlet box so that it will support at least 35 pounds.  
Note: the weight of the fan is as follows:  
BOLT  
BUSHING  
SET SCREW  
PFC-48 14 lbs.  
PFC-56 20 lbs.  
LOWER  
CANOPY  
LOCK  
BOLT  
LOCATION  
1. When fan is installed, you must allow a minimum of 10  
feet between floor and bottom of fan blades.  
BLADE  
2. For this model, the center of the fan must be located at  
least 32" from any vertical surface – wall, doors, partitions,  
etc. This allows minimum clearance for fan blades.  
BLADE HOLDER  
GASKET  
MOTOR UNIT  
FIGURE 1  
3. Do not mount fan below, next to or between air ducts,  
beams or any other obstructions which may interfere with  
the natural air flow pattern created by the fan.  
4. Place fans near constantly opening doors and shipping  
bays to produce and “air shield” effect that helps keep out  
cold air in winter and dust, odors and insects in the  
summer.  
GREEN  
SUPPLY GROUND  
GREEN  
WHITE  
BLACK  
SUPPLY NEUTRAL  
SUPPLY HOT  
5. If desired, fans can be installed directly above heat  
producing machinery to reclaim the heated air.  
6. For maximum air flow, fans should be located above  
aisles in warehouses and storage areas.  
7. Make sure fan voltage is compatible with you electrical  
system.  
FIGURE 2  
HOW TO ASSEMBLE  
1. Locate down rod and remove spring bushing from hole in  
side of rod. Locate upper canopy and remove three  
screws holding fan mounting bracket in canopy. Place  
upper canopy over down rod with open end toward plastic  
ball hanger. Locate lower canopy and place over down rod  
with open end facing away from plastic ball hanger.  
Replace spring bushing into hole in side of down rod.  
2. Feed white, black, and green supply wires from motor  
through the bushing in the down rod and up through the  
down rod.  
 

Miele Vacuum Cleaner HS09 User Manual
Napco Security Technologies Computer Hardware GEM RS232 User Manual
NHT Speaker Evolution System User Manual
Nintendo Video Game Console 45496880019 User Manual
Nintendo Video Games AGB BZ6E USA User Manual
Olympus Camera Accessories PT 019 User Manual
Optiview Security Camera 30XSPD User Manual
Oricom Telephone HP100 User Manual
Panasonic Amplified Phone KX TG7511 User Manual
Patton electronic Network Router 07MOS10xx QS User Manual